residual factor

Present land laws, household register regulations, the procession of urbanization and the education level of rural residual labor force are the main factor that influence the problem of rural residual labor force transfer.

现行土地制度、户籍管理制度、城市化进程以及农村剩余劳动力素质是制约农村剩余劳动力转移的主要因素。

Once compressive residual stress is induced in the notched area, the residual stress concentration factor can be higher than the theoretical stress concentration, therefore the notched fatigue limit can be higher than the highest smooth fatigue limit.

缺口试件引入残余压应力，由于应力集中效应，缺口根部的残余应力集中系数可能高于理论应力集中系数，因而其疲劳强度将超过最高的光滑试件疲劳强度。

The fatigue strength can be remarkably increased after rolling, the reason is that there are the high residual compressive stresses in the surface stories; except that, the homogenizing of the microscopic stresses in the tempered martensite is an important factor.

对低温回火试样，滚压可显著地提高其疲劳强度，其原因除表层有较高的残余压应力外，滚压使表层回火马氏体内的微观应力均匀化也是一个重要因素。

Melting Residual Stress is the main factor Causing Stress erosion damage on Austenite Rustless Steel's Structures.

焊接残余应力是奥氏体不锈钢发生应力腐蚀破坏的重要因素.

To meet the residual strength requirement, it takes the stress intensity factor K1C/ 1. 2 as the termination condition in crack propagation calculation in the article.

为保证剩余强度要求，本文通过在裂纹扩展计算中以应力强度因子达到K（1c）／1.2作为终止条件来实现。

It was found that tension residual stress is key factor for crack growth under cyclic compression.

结果表明,裂尖区域在循环压缩载荷作用下的残余拉伸应力是导致裂纹扩展的重要因素.

The diameter of actual tangent circle is an important parameter for safety of boiler, the residual rotation is the key factor of flue gas temperature deviation at furnace exit.

实际切圆直径是锅炉稳定安全运行的一个重要参数，炉膛出口残余旋转是造成烟温偏差的主要原因。

Weld residual stress degree of irregularity is the important influencing factor for equipment life.

金属焊接引起的残余应力分布的不均匀程度是影响设备寿命的重要因素.

Relationship between pluripotency maintenance of residual embryonic stem cells and exogenous leukemia inhibitory factor

类胚体中残留细胞分化全能性维持与外源性白血病抑制分化因子的关系

Residual stress is the main factor affecting the flatness of plate.

残余应力是影响矫后中厚板平直度的主要因素.